This is a working overview of Stationary phase, written for readers who want more than a one-paragraph summary but less than a textbook.
Reviewed 2026-07-19. Anything still debated is marked as such rather than presented as settled.
Routine quality control monitors retention time shifts, baseline noise, system pressure, and peak shape. Trends can reveal column aging, mobile phase preparation errors, detector drift, or sample degradation. Corrective actions may include replacing the column, preparing fresh mobile phase, or recalibrating the detector. Stability testing often uses HPLC to measure parent compound loss and degradation product formation. Open questions remain about how accelerated stability results extrapolate to long-term storage under varied conditions.
Quality control for HPLC testing combines scheduled checks, documented procedures, and review of results. Before sample analysis, system suitability testing confirms that the instrument, column, and method meet predefined criteria. Common criteria include resolution between critical peaks, retention time precision, peak tailing, and theoretical plate count. Failure triggers investigation before results are reported. Records link raw data, calculations, instrument logs, and analyst identity to each batch, supporting audits and repeat analysis.
Validation demonstrates that a method is suitable for its intended use. Typical performance characteristics include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, and robustness. Regulators and standards organizations provide frameworks, but specific requirements depend on the application and jurisdiction. System suitability tests are run before sample analysis to confirm resolution, peak symmetry, retention time repeatability, and sensitivity. A validated method is not permanently fixed; changes may require partial or full revalidation.
Routine HPLC testing depends on controlled reagents, calibrated instruments, and documented procedures. Columns degrade over time, so retention times and peak shapes are monitored for drift. Mobile phases are filtered and degassed to prevent pump damage and detector noise. Reference standards must be traceable and stored under suitable conditions. Data handling systems record injections, calculations, and audit trails. Quality control samples interspersed with unknowns help detect errors during a run.
Developing an HPLC method begins with defining the purpose, such as quantifying a main component, measuring impurities, or confirming identity. Analysts select separation mode, column, mobile phase, detection, and sample preparation based on analyte properties and matrix. Experiments vary solvent strength, pH, buffer type, and temperature to achieve resolution between critical peaks. The goal is a robust method that produces reliable results across instruments and operators. Method development often involves trial runs and statistical optimization.
| Property | Value | Notes |
|---|---|---|
| Retention time RSD | ≤1% for five replicate injections | Typical criterion; method-specific limits apply. |
| Resolution | ≥1.5 between critical pair | Baseline separation is generally desired. |
| Tailing factor | ≤2.0 | Measures peak symmetry. |
| Theoretical plates | ≥2000 per column | Method-dependent; higher values indicate greater efficiency. |
| Peak area RSD | ≤2% for replicate injections | Reflects autosampler and detector precision. |
Practical HPLC testing depends on careful sample preparation and instrument maintenance. Samples may require filtration, dilution, pH adjustment, or extraction to avoid column damage and matrix interference. Mobile phases are degassed and filtered, and columns are equilibrated before injection. Common problems include peak tailing, baseline drift, ghost peaks, carryover, and co-elution of analytes. Documentation of instrument logs, calibration records, and electronic audit trails supports data integrity and traceability. Ongoing training and routine maintenance help reduce variability between analysts and laboratories.
Quality control laboratories use HPLC to check identity, purity, concentration, and stability of raw materials and finished products. A validated method specifies the column, mobile phase, flow rate, detection wavelength, injection volume, and run time. Samples are prepared and compared against reference standards of known concentration. The resulting chromatogram provides quantitative data, such as assay values and impurity levels. This approach is common in pharmaceutical, food, environmental, and industrial testing where consistent measurements are required.
Instrumentation includes a solvent delivery system, an autosampler, a column oven, and one or more detectors. Reversed-phase columns with chemically modified silica are widely used, but normal-phase, ion-exchange, size-exclusion, and affinity modes exist for specific separations. Detectors may rely on ultraviolet absorbance, fluorescence, refractive index, or mass spectrometry. Column temperature, mobile phase composition, and flow rate are adjusted to improve resolution. System pressure is monitored because rising pressure can indicate column blockage or deteriorating packing.
Separation performance depends on particle size, pore size, column length, and the chemistry of the stationary phase. Smaller particles generally improve efficiency but require higher pressure and suitable instrumentation. The mobile phase often contains buffers and organic solvents that influence retention and selectivity. Testing labs select conditions based on the analytes, sample matrix, and required sensitivity. Method development frequently involves screening several columns and solvent mixtures before a final set of conditions is chosen.
High-performance liquid chromatography is an analytical technique that separates components in a liquid sample. A pump moves a liquid mobile phase through a column packed with a solid stationary phase. Compounds interact differently with both phases and travel at different rates, leaving the column at distinct retention times. A detector records these arrivals as peaks on a chromatogram. The resulting pattern supports identification and quantification of substances in mixtures. Modern instruments use high pressure to force solvent through small particles, which improves speed and resolution compared with older low-pressure liquid chromatography methods.
Separation in HPLC depends on the chemistry of the stationary phase, the composition of the mobile phase, and the physical properties of the column. Reverse-phase separations use a nonpolar stationary phase and a polar mobile phase, and they are common for many organic compounds. Ion-exchange, size-exclusion, and normal-phase modes serve other classes of analytes. Gradient elution changes solvent strength over time, while isocratic elution holds it constant. Flow rate, temperature, particle size, and column length all influence peak shape and resolution. Detection may use ultraviolet absorbance, fluorescence, refractive index, or mass spectrometry, depending on the analyte and the required sensitivity.
The Edman degradation is an alternative method for peptide sequencing that cleaves amino acid residues from the N-terminus of a peptide. In 1950 Edman designed a reaction with phenylthiocyanate (the idea for which was borrowed from a 1927 study by Bergmann, Kann and Miekeley ) to give phenylthiocarbamyl peptides followed by hydrolysis under relatively mild conditions to cleave N-terminal amino acid as phenylthiohydantoin. Phenylthiohydantoin is stable enough to undergo various sequencing procedures such as those which involve chromatography and mass spectrometry. This was an improvement on an earlier method proposed by Abderhalden and Brockmann in 1930 that demonstrated N-terminal amino acid conversion to a hydantoin under stronger hydrolytic conditions, where some cleavage of the residual peptide proved problematic. The primary advantage the Edman degradation has over the Bergmann degradation is the ease with which the residual peptide can re-enter the process due to retention of its structure throughout sequential cleaving. Repetition of the Bergmann degradation is presumably not as straightforward, as the remaining peptide is in amide form.
Anne-Claude Gingras is a senior investigator at Lunenfeld-Tanenbaum Research Institute, and a professor in the department of molecular genetics at the University of Toronto. She is an expert in mass spectrometry based proteomics technology that allows identification and quantification of protein from various biological samples. Gingras was born on Île d'Orléans, Quebec. She earned her undergraduate degree at Université Laval in Quebec. She completed her PhD in biochemistry at McGill University in Montreal, studying how 4E-BP1 regulated translation initiation, under the mentorship of Nahum Sonenberg. After graduating in 2001, she began postdoctoral research in Seattle at the Institute for Systems Biology in the lab of Ruedi Aebersold, where she studied proteomics for three years. In 2005, Gingras moved to Toronto and joined the Lunenfeld-Tanenbaum Research Institute, and in 2006, she began teaching at the University of Toronto in the department of molecular genetics.
While Aβ has been implicated in cancer development, prompting studies on a variety of cancers to elucidate the nature of its possible effects, results are largely inconclusive. Aβ levels have been assessed in relation to a number of cancers, including esophageal, colorectal, lung, and hepatic, in response to observed reductions in risk for developing Alzheimer's disease in survivors of these cancers. All cancers were shown to be associated positively with increased Aβ levels, particularly hepatic cancers. This direction of association however has not yet been established. Studies focusing on human breast cancer cell lines have further demonstrated that these cancerous cells display an increased level of expression of amyloid precursor protein. Adults with Down syndrome had accumulation of amyloid in association with evidence of Alzheimer's disease, including declines in cognitive functioning, memory, fine motor movements, executive functioning, and visuospatial skills.
Depending on the column size, CIM monolithic columns are primarily used for the purification or analysis of large biomolecules which are being used for cancer gene therapy, treatment of viral infectious diseases and treatment of genetic diseases. Some types of molecules that can be successfully purified using CIM columns are pDNA, IgM, inter-alpha inhibitors, virus like particles, and diverse viruses; adenoviruses, bacteriophages, feline calicivirus, hepatitis A, lentivirus, influenza A and B, rabies virus, rotavirus, tomato and pepino mosaic virus. Since 2004, BIA Separations has organized and hosted the Monolith Summer School and Symposium (MSS) which takes place every 2 years. MSS was established as there were no dedicated conferences to this technology and to bring together the top international scientists and researchers in the area of monolith chromatography to share their experiences and innovative applications. BIA Separations home page Monolith Events
Sources: en.wikipedia.org
The ADGRG1 protein couples to Gαq/11 protein upon association with the tetraspanins CD9 and CD81. Forced ADGRG1 expression activates NF-kB, PAI-1, and TCF transcriptional response elements. The splicing of ADGRG1 induces tumorigenic responses as a result of activating the transcription of genes, such as COX2, iNOS, and VEGF85. ADGRG1 couples to the Gα12/13 protein and activates RhoA and mammalian target of rapamycin (mTOR) pathway upon ligand binding. Lack of the N-terminal fragment (NTF) of ADGRG1 causes stronger RhoA signaling and β-arrestin accumulation, leading to extensive ubiquitination of the C-terminal fragment (CTF). Finally, ADGRG1 suppresses PKCα activation to regulate angiogenesis.
In the UK, a House of Commons Select Committee on Environment, Food and Rural Affairs report on the horse meat incident was not critical of UK or Irish producers. It expressed concern that horsemeat contamination resulted from fraud and other criminal activity across the EU. Chair of the Committee, Anne McIntosh MP, said: "The evidence suggests a complex network of companies trading in and mislabelling beef or beef products which is fraudulent and illegal." The second major UK report on the horse meat incident was conducted by Professor Chris Elliott, the Director of the Institute for Global Food Security at Queen's University Belfast. In his independent report, he argues that food crime was at the heart of the horsemeat incident and makes a range of suggestions for how this could be tackled. "Industry, government and enforcement agencies should, as a precautionary principle, always put the needs of consumers above all other considerations, and this means giving food safety and food crime prevention—i.e. the deterrence of dishonest behaviour—absolute priority over other objectives."
The 2025 Cleveland Guardians season was the 125th season for the franchise, which competes in the American League of Major League Baseball (MLB). On July 6, they were 15.5 games back of the first place Detroit Tigers and were as many as 11 games back on September 4. However, the Guardians surged while the Tigers collapsed and took the American League Central lead on September 23 with a win over the Tigers. With the Guardians having trailed Detroit by 15.5 games in July, this ranked as the largest divisional comeback in MLB history. In addition to the historic division comeback, the Guardians also became the fifth team to make the playoffs while being sub-.500 on September 4 or later. On September 27, with a walk-off win over the Texas Rangers, the Guardians clinched a postseason berth, taking the sixth and final postseason spot in the American League. On September 28, with the Tigers' loss to the Red Sox, the Guardians clinched the American League Central division for the second consecutive time and the sixth time in ten years (2016–2018, 2022, 2024–2025). However, they lost to the Tigers in the Wild Card Series.
Dietary supplement companies aggressively promote NMN products claiming these benefits. NMN is a precursor to NAD+ biosynthesis, and dietary NMN supplementation has been shown to increase NAD+ concentrations and thus has the potential to mitigate aging-related disorders such as oxidative stress, DNA damage, neurodegeneration, and inflammatory responses. The potential benefits and risks of NMN supplementation as of 2023 are currently under study. Life extension Anti-aging movement
The Public Affairs Office works with the PAAC to advocate for increased research budgets for the major governmental funding agencies, primarily the National Institutes of Health and the National Science Foundation. ASBMB has developed a set of recommendations for pre-medical course requirements consistent with the new Medical College Admission Test. Advocacy efforts also focus on protecting the conditions that promote a successful research environment. In addition, the office works to maintain a healthy relationship between ASBMB members, government officials, and the public in order to foster awareness of the importance of science to everyday life. As part of their advocacy efforts, ASBMB organizes Capitol Hill Day, an annual event that allows graduate students and trainees to meet their congressional representatives in Washington, D.C. List of biochemistry awards Official website American Society for Biochemistry and Molecular Biology records, 1906-2005 at the University of Maryland, Baltimore County
Sources: en.wikipedia.org
System suitability is typically performed before each batch or according to the validated method and laboratory procedure. Some long runs include periodic checks during analysis. The required frequency depends on regulatory expectations and method performance.
Retention time drift can result from changes in mobile phase composition, column temperature, pump flow, or column age. A gradual shift often points to column degradation. A sudden shift may indicate a leak, mixing error, or incorrect mobile phase.
Retention time alone cannot confirm identity because different compounds may elute at similar times. Coupling HPLC with mass spectrometry or comparing against authenticated standards increases confidence. Confirmation usually requires orthogonal data.
It is a set of checks performed before or during an HPLC run to confirm the system works as expected. Parameters may include resolution, tailing factor, theoretical plates, and retention time precision. Failure can trigger maintenance, method adjustment, or repeat analysis.